Go Bottom

250 oil leak pushrod tubes

View my Photos
belarus250
Join Date: May 2008
Posts: 30 NE
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2008-05-14          153698


Can someone tell me how to replace the seals at each end of the tubes that contain the pushrods. I have a bad leak at the top and bottom of one pushrod tube on the rear cylinder. For some unknow reason the last person in put hose clamps on each end of the tubes in an attempt to perhaps hold the tubes up against the seals? The worst leak is the upper seal.
Sure would like to know how much I have to take apart to replace them. I hope it's just the rocker cover, rocker shaft and rockers and not the whole head on that cylinder.

The seals look brittle, I guess the heat beats them up good.
Thanks in advance for any help with this.
Ken




Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



250 oil leak pushrod tubes

View my Photos
vladimirec
Join Date: Mar 2009
Posts: 29 Croatia
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2009-03-10          160938


You have to remove head, after that it's simple. take out the tube and replace o-rings. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login