Go Bottomsmall rotary cutter
 | Tim Campbell
Join Date: Posts: 1 
|
2000-07-28 18338
I'm looking for a 42" rotary cutter. Any suggestions?
Reply to |
Quote Reply |
Add Photosmall rotary cutter
| KenB
Join Date: Posts: 1
|
2000-07-31 18407
I have a "Sunshine" mower manufactured by Modern Mfg. of Beaumont, TX. I'd classify this as a very light duty cutter. After a year of use, the box itself started to come apart at the seams and a local welding shop had to stitch it back together and reinforce it for me. It's lasted for 5 years now, but it was a major rebuild. If I had it to do over again, I'd try to find a heavier-duty unit. ....
Reply to |
Quote Reply |
Add Photosmall rotary cutter
| Tim Campbell
Join Date: Posts: 1
|
2000-08-03 18503
Ken:
Thanks for the tip! ....
Reply to |
Quote Reply |
Add Photosmall rotary cutter
| Glenn
Join Date: Posts: 1
|
2000-08-04 18510
Hello:
I have a 48" John Deere Model 413 shredder and a 48" BushHog finish mower. The BushHog is a rear mount and it has two blades instead of three, as seems to be more common. It discharges to the right, but I bolted a steel plate over the discharge to better protect my windows and my air conditioner and to further mulch grass clippings. Both the John Deere and the BushHog are well made and heavy as sin. I have used them for a year and had no problems. It's hard to find narrow units and, of course, they do have to be wide enough to extend over the width of both rear tires of the tractor. Good luck! ....
Reply to |
Quote Reply |
Add Photo
Go Top
Share This