Skid plate to protecct tie rod
Paul Fox
Join Date: Posts: 1 |
2001-04-27 27301
A while back, the subject of bent tie rods came up. One of the responders asked me to post a picture of the skid plate I fashioned to keep from bending mine yet again. It's made out of some 7/8's bar stock I happened to have lying around, with a 1/8 plate welded to the bottom. I'd have gone heavier (probably 1/4) if I'd had any at the time.
Picture Link
Reply to | Quote Reply | Add Photo
Skid plate to protecct tie rod
Ted Kennedy
Join Date: Posts: 1 |
2001-04-28 27326
Paul, Very Nice Job! ....
Reply to | Quote Reply | Add Photo
Go Top
Share This