Jones
D
Join Date: Posts: 1 |
2004-04-11 82730
I have a JD 48C mower deck that I am trying to change the blades on. I have changed blades before but these blades are seized. I have tried t get them off with a 1/2" drive and socket but the bolt heads measure 23/32 and I can only get a 3/4" to fit. These bolts should turn lefty loosey but i cannot get tyhem to unseat in either direction.
Can someone post an idea here.
Reply to | Quote Reply | Add Photo
Jones
Billy
Join Date: Oct 1999 Posts: 975 Southeast Oklahoma Pics |
2004-04-11 82732
First make sure the direction is right and then use an impact wrench. I tried for a half a day to get the blades off of a Landpride mower without any success. I drove the tractor over to a local garage and borrowed their impact wrench. It took maybe 2 minutes to take the 3 old blades off and install the new ones.
I do have an impact wrench now. ....
Reply to | Quote Reply | Add Photo
Jones
Murf
Join Date: Dec 1999 Posts: 7249 Toronto Area, Ontario, Canada Pics |
2004-04-12 82824
Two points to consider;
First of all I think you will find those bolts are 18mm or 19mm not 3/4".
Secondly, are you sure you're not trying to TIGHTEN those blades, most of them are on a LEFT-HANDED thread so they don't come loose in operation.
Best of luck. ....
Reply to | Quote Reply | Add Photo
Go Top
Share This