Go Bottom

Mitsubishi FD2650 FEL

View my Photos
kwindle
Join Date: Mar 2009
Posts: 6 Texas
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2010-07-12          172262


Is there a repair/parts manual for the "factory" Mitsubishi front end loader? The loader has FD2650 stamped on it so I assume it is a factory unit. I've developed a lift problem ...the bucket roll works fine but the lift is weak(only lift about 200 pounds). I would assume I probably have some trash in a hose or valve body or a pop off valve issue, but don't know enough about hydraulics to tear into it without a manual or some guidance.



Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
auerbach
Join Date: Sep 2007
Posts: 2168 West of Toronto
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2010-07-17          172348


Not that I've seen everything but I've never seen an FEL that wasn't designed and didn't work just like all the others. So any hydraulics shop that does tractors or tractor shop that does hydraulics can handle it.

But first, a pinhole in a hose can cause it. Unless your fluid level is staying constant over a long period under the same conditions, wrap a paper towel around them to detect any leak.

Then, if you have quick connectors, check each is seated properly. Next interchange those at the controller to identify which of the four lines does what and which line or spool is blocked or defective.

(All assuming that it used to work right and this is recent.) ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
lsheaffer
Join Date: Jun 1999
Posts: 1082 Northern Illinois
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2010-07-20          172441


I would suspect bad lift cylinder seals. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
auerbach
Join Date: Sep 2007
Posts: 2168 West of Toronto
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2010-07-21          172452


If the other tests don't help and you can't get the tractor to a shop, Len is likely right. After the system is totally depressurized remove the lift cylinders znd take or send them for new seals. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
kwindle
Join Date: Mar 2009
Posts: 6 Texas
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2010-07-21          172454


Thanks for all the replies. Hopefully within a week or two, I'll have time to tear into it and give these suggestions a try. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
groupw50
Join Date: Sep 2011
Posts: 2 Washington State
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster

2011-09-26          180580


Did you ever find a manual? If so, where I am looking for a manual also. I have a 2650 FD Mitsubishi also. Thanks AJ ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
lsheaffer
Join Date: Jun 1999
Posts: 1082 Northern Illinois
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-09-27          180589


I can supply you with manuals. ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo



Mitsubishi FD2650 FEL

View my Photos
DennisCTB
Join Date: Nov 1998
Posts: 2707 NorthWest NJ
TractorPoint Premium Member -- 5 Tractors = Very Frequent Poster  View my Photos  Pics

2011-09-27          180591


Contact Lsheafer at:

sheaftractor at grics.net
www.japanesetractorparts.com ....


Reply to | Quote Post Reply to PostQuote Reply | Add PhotoAdd Photo


   Go Top


Share This







Member Login